Lokar Automatic Trans Mount Shifter TH400 User Manual

Page 4

INS0080 Rev. 05/09/14

Page 4

Step 11: Put the shifter into the Park position and check the position of the quad lever.

It will need to be pointing to about the 4:30 position. If it is not, loosen the set

screw in the top of the quad lever with a 1/8" Allen wrench and slide the quad

lever off of the shaft. Reposition it on the shaft at approximately the 4:30

position, and retighten the set screw.

Fig. 6

NOTE: If your shifter is placed near the front of the bracket assembly, you may

need to position the quad lever slightly higher, such as at the 4:00 position

instead. This will help prevent over-centering the trans gear lever.

Step 12: Remove the rod end from the new trans gear lever. Install the trans gear lever

onto the transmission and secure with your original nut. Place the trans gear lever

in the Park position with the top of the lever pointing up and slightly towards the

rear of the transmission, at about the 1:00 position.

Fig. 7

Step 13: The threaded rod will connect the quad lever to the trans gear lever. Check to

make sure that nothing will interfere with the travel of the threaded rod. If there

is any interference, the threaded rod can be bent slightly as needed.

Verify that both the shifter and the transmission are in the Park position.

Measure center-to-center between the 1/4" holes in the trans gear lever on the

transmission and the quad lever on the shifter. Subtract 1-3/4".

Fig. 8 This is

the length you will cut the threaded rod to. Use a hacksaw or other metal-cutting

saw to shorten the threaded rod.

Step 14: Install a rod end onto each end of the threaded rod. Attach the threaded rod

assembly to the

inside of the trans gear lever and to the outside of the quad lever

using the 1/4"-28 x 1" button head bolts, flat washers, and nylock nuts as shown

Fig. 9 and Fig. 10. The button head bolts can be installed from either direction,

but make sure the rod end is sandwiched between the flat washer and the quad

lever or trans gear lever.

Fig. 7

Fig. 9

Threaded Rod

NOTE: Bolt can be installed from

either side. Make sure Rod End is

sandwiched between Flat Washer

and Trans Gear Lever.

1/4"-28 Jam Nut

1/4"-28 x 1"

Button Head Bolt

Flat

Washer

Rod

End

Trans Gear

Lever

1/4"-28

Nylock Nut

Trans Gear Lever at

approximately 1:00

position in Park

Lokar Electric Kickdown Kit

(not included, available separately)

Measur

e This Distanc

e and Subtr

act 1-3/4"

Fig. 8