Accton Technology ES4512C - Manual (Page 119)

Port Configuration
3-81
3
Web – Click Port, Port/Trunk Broadcast Control. Check the Enabled box for any
interface, set the threshold and click Apply.
Figure 3-47. Port Broadcast Control
CLI – Specify any interface, and then enter the threshold. The following disables
broadcast storm control for port 1, and then sets broadcast suppression at 600
packets per second for port 2.
Console(config)#interface ethernet 1/1 4-125
Console(config-if)#no switchport broadcast 4-131
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#switchport broadcast packet-rate 600
4-131
Console(config-if)#end
Console#show interfaces switchport ethernet 1/2
4-135
Information of Eth 1/2
Broadcast threshold: Enabled, 600 packets/second
Lacp status: Disabled
Ingress rate limit: disable,1000M bits per second
Egress rate limit: disable,1000M bits per second
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Disabled
Allowed Vlan: 1(u),
Forbidden Vlan:
Console#