Flex-a-Lite 4116C COOLER KIT - CAMARO 2010-2011 - Manual (Page 3)

Rev. 02-13-12 98116 Page 3 of 4
Installation instructions continued from previous page
Attach provided hoses (2ea) to fittings of cooler utilizing provided hose clamps (2ea). 7.
Position large plastic spacer (2ea), 1ea. per hole, above / aligned with the holes at bottom of plastic 8.
cowling. These spacers act to space the bottom cooler bracket just off the bottom.
Position the cooler/bracket assembly onto the large plastic spacers. Place lock washers 5/16” (2ea) onto 9.
bolts 5/16-18 x 1-1/2” (2ea) and insert bolts through bottom bracket, through large plastic spacers, through
plastic cowling and finally into pre positioned u-nuts.
Thread bolts in loosely but do not tighten just yet.
When the cooler assembly is in place, feed the attached hoses through the molded opening of the plastic
cowling at bottom along driver’s side.
(see Detail F & G)
Place lock washers 5/16” (2ea) onto bolts M8-1.25 x 30mm (2ea) and insert bolts through top bracket, large 10.
plastic spacers (2ea), 1ea. per hole and align with threaded holes near top of radiator support. The target
holes are just under the threaded holes used to secure the hood latch mechanism.
(see Detail H on next page)
Go back and tighten all mounting hardware when the cooler/bracket assembly has been properly 11.
positioned.
Close up view of cooler secured to channel.
Tubes of cooler are sandwiched between gator
clips then attached to channel at four spots. Each
spot is secured with bolt and nyloc nut.
Close up view of channel secured to top bracket.
Leave cap screws loose during installation. After top
and bottom brackets are secured to vehicle go back
and tighten cap screws to channels.
Detail F
Mounting position of bottom bracket
Detail G
Hose clamp
Rout hoses through bottom opening
on driver’s side