Flex-a-Lite Translife Cooler & Guard Kit - Manual

1
INSTALLATION INSTRUCTIONS Assemble & Install Cooler and Guard Kit
1. Temporarily attach the nylon GatorClips® to the
cooler.
2. Orient the cooler so fittings point toward the
most direct route to the transmission oil lines.
3. Mark center of bolt locations and drill a 5/16”
hole through panel or brackets the remote cooler
will be mounted to.
NOTE: All Flex-a-lite oil cooler kits can also be
mounted using our Accessory Bracket Set. Visit
Flex-a-lite.com for details on these mounting
accessories to fit your application.
4. Place (4) supplied spacers between the cooler
guard and the GatorClips®.
5. Attach guard and cooler to panel or bracket
using the supplied bolts, washers and lock nuts as
shown in the diagram to the left.
6. Attach included hose to cooler and vehicle lines
using included hose clamps. (If cutting factory
metal lines we highly recommend double
flaring the ends to prevent abrasion to the
hose).
7. Top off fluid and bleed lines of all air and enjoy
your new Translife Cooler & Guard!
Translife Cooler & Guard Kit
Our Flex-a-Lite Cooler & Guard kit adds both style
and protection to any cooler install. With the use
of our patented GatorClips®, your new cooler can
be securely mounted to your vehicle; either
directly with the included hardware, or by using
one of our optional Accessory Bracket Sets . Visit
www.flex-a-lite.com to learn more.
98420 Rev. 01-22-14
What’s Next?
Register your product for warranty at
http://automotive.flex-a-lite.com/warranty-
registration/
Enjoy your Flex-a-lite performance cooling
product!
If you need further assistance, please contact tech
services at 253-922-2700 M-F 8:00am-5:00pm PST.
1
2
3
4
5
6
7
8
9
10
1. Bolt
2. Washer
3. Guard
4. Spacer
5. GatorClip®
6. Cooler
7. GatorClip®
8 GatorClip®
9. Washer
10. Nut