Flex-a-Lite 328: puller with out controls LoBoy Fan & Aluminum Shroud for Ford Coup 1930-34 - Manual

LoBoy Fan & Aluminum Shroud
for Ford Coup 1930-’34
Part #318: puller with controls
#328: puller with out controls
Assembly & Installation Instructions
1. First, attach the supplied fan to the fan shroud as
shown using the screws, washers, and nuts provided
(see
Diagram A).
2. Prepare the radiator for shroud installation by
clearing the core surface.
3. Find the rubber strips included in the kit and
trim 2 strips to the length of the shroud. These
will be used between the shroud and radiator
to isolate vibration (see
Diagram B).
4. The shroud can be mounted to the radiator by
using the flanges between your radiator tanks.
Place the shroud over the flanges. Using the
holes in the aluminum shroud as a template, mark
and drill holes through the flanges on your radiator.
It may be helpful to have a friend hold the shroud
while you mark and drill the holes.
NOTE: Use caution when drilling the mounting
holes. Do not drill into the radiator core!
5. Attach the fan and shroud assembly to the radiator
using the small #10 screws, and washers as shown
(see
Diagram B).
NOTE: Be sure to use the rubber cushioning strips
between the shroud and radiator as shown!
Diagram A
Diagram B
Continue to next page
for wiring instructions
Rev. 07-13-10 99318 Page 1 of 3