Flex-a-Lite 56400 Camaro Radiator Fits 1982-1992 - Manual

Camaro Radiator #56400
Fits 1982-1992
INSTALLATION INSTRUCTIONS
REMOVAL OF EXISTING FAN AND SHROUD ASSEMBLY:
1. Make sure the engine is cool!
2. Disconnect negative (-) battery cable from battery.
3. Remove “Z” shaped air ducting between air filter canister and flexible air duct.
Note: If your vehicle
comes equipped with a strait forward or other air ducting configuration, remove it. (see detail 1)
4. Remove remaining flexible air duct attached to intake manifold. Remove intergraded tube as well
leading to passenger side valve cover. (see detail 1)
5. Remove air ducting support bracket from top radiator bracket, and remove or detach Air Conditioning
(A/C) lines (if equipped) from shroud.
6. Pull A/C lines away from top of radiator and hold in place over motor; this gets the hoses out of the way
for better access. Tip: Try using long zip ties to secure loose objects in place as needed.
7. Remove electrical or clutch fan at this time
8. Release wire loom from mounts on lower metal support bracket (supporting bottom radiator hose). Pull
bottom radiator hose out of bracket. (see detail 3 on page 2)
9. Remove the bolts holding together the following items:
a. Power steering cooling lines.
b. Lower frame cross member.
c. Plastic bottom fan bracket.
Note: You will be reusing the metal support bracket, plastic bottom
fan bracket and bolts during new radiator installation. (see detail 8 on page 3)
10. Remove radiator cap and drain radiator; drain valve is on passenger side at bottom.
11. Disconnect the following:
a. Overflow hose leading to coolant reservoir.
b. Bottom radiator hose from radiator and let remaining coolant drain.
c. Top radiator hose from radiator.
12. Remove the bolts (4) securing top radiator bracket to top cross member and top of radiator. Note: Save
the bolts to be reused later. (see detail 2)
13. Pull the original radiator up & out from the engine compartment then set it aside. (see detail 4 page 2)
14. Clean out any debris (leafs, bugs, dirt, coolant) from bottom cross member where original radiator
previously rested.
Flexible air duct
(Detail 1)
Top radiator bracket
(Detail 2)
07-01-08 #99400 Page 1 of 3