EOTech CNVD-T3 Clip-On Night Vision Device - Thermal 3 - Manual (Page 43)

2-25
Figure 2-23 Menu - Exit
NOTE
The message “NO SAVE” will appear at the
bottom of the display if settings could not be saved
due to low battery power. Changes will be made,
but not saved for future use.
2.14 SHUTDOWN PROCEDURES
a. Press and hold the POWER button for
approximately 3 seconds as the messages OFF?
then OFF! appear sequentially in the eyepiece
display. Release the POWER button when the
eyepiece display turns dark.
b. Install objective lens cover over the objective lens.
c. Remove batteries; place batteries and the CNVD-T3
in the soft carrying case.
Or to exit any
time: or
ZOOM 1X
WHOT
CAL
RETINT
RET
PIC
REV
MCAL
RS170
HAND
EXIT