EOTech CNVD-T3 Clip-On Night Vision Device - Thermal 3 - Manual (Page 28)

2-10
2.8 SYSTEM RESET
Simultaneously pressing (and holding) both the UP and
DOWN buttons resets the CNVD-T3 to the following default
parameters:
a. Polarity is set to white hot (WHOT);
b. Magnification is set to ZOOM 1X;
c. Brightness is set to mid-scale;
d. Gain is set to AUTO-LOW;
e. The MCAL menu option is activated; and
f. The CLIPON menu option is activated.
Note that reticle positioning adjustments are not changed
during system reset.
2.9 BRIGHTNESS ADJUSTMENT
When the Main Menu is NOT displayed, pressing either the
UP or DOWN button calls up the brightness control settings.
Brightness controls are presented in the eyepiece display as
shown in Figure 2-6.
+
-
Figure 2-6 Brightness Control
Brightness of the display is adjusted by pressing the UP /
DOWN buttons to move the status bar along the + / - scale.
Repeatedly pressing the UP / DOWN buttons will move the
Status Bar