EOTech CNVD-T3 Clip-On Night Vision Device - Thermal 3 - Manual (Page 20)

2-2
2.2.2 Battery Installation . Proper battery orientation is
clearly marked on the CNVD-T3 housing. Unscrew the
battery cap and install the first DL123A lithium battery. Tilt
the CNVD-T3 to allow the battery to slide into the battery
compartment, thereby providing space to insert the second
battery. Install the second battery, then replace and screw in
the battery cap.
Figure 2-1 Battery Installation
CAUTION ..
Do not ship or store the CNVD-T3 with batteries
installed.
2.2.3 Low Battery Power. A low battery message will
appear in the eyepiece display when approximately 20
minutes of continuous operation remain. If the batteries are
not replaced promptly when the “LOW POWER” message
appears, the display quality will deteriorate rapidly.