BMR Suspension TAS012 User Manual
Page 8
8
(CONTINUED)
15. Install the BMR control arm mounts onto the axle using the supplied U-bolts. The open
portion of the mount should face forward as shown in Image 8a and 8b below. NOTE:
You may omit the inner U-bolt and use the factory 7/16” carriage bolts, if preferred.
Doing so will prevent brake line interference on the top of the axle. Tighten nuts to 60
ft/lbs.
16. Lift and insert the other end of the control arm into the axle brackets on the highest
mounting hole and insert the supplied ½” x 3.25” bolts. Place a stainless washer under
the nut but leave this connection loose until a later step. NOTE: it may be necessary to
adjust the length of the control arms to match the holes in the control arm mounts. It
may also be necessary to move the rear end forward or back to line the mounting holes
up. If one trailing arm is adjusted, duplicate this procedure on the other arm and verify
that they are equal in length before proceeding to the next step.