BMR Suspension XSB002 - Manual

1
4
th
GEN F-BODY XTREME REAR ANTI-ROLL BAR INSTALLATION
XSB001, XSB002 – 1982-2002 Camaro and Firebird
RECOMMENDED TOOLS:
Wrenches – ½”, 9/16”, ¾”(2)
Sockets – 10mm, ½”, 13mm, 9/16”, ¾”,
3/8” drive ratchet
Drill with ½” drill bit (angle drill is preferable)
Hydraulic jack and jack stands (or service lift)
NOTE: Use of an adjustable panhard rod is highly recommended before proceeding with this installation. Adjustable panhard rods
allow the user to properly center the rear end in the chassis, a necessary requirement for the installation of this product.
INSTALLATION:
1. Lift the vehicle and safely support it under the axle with jack stands. The installation is much simpler with the suspension
loaded. Remove wheels/tires.
2. Using a 13mm wrench and socket, remove the nuts from the sway bar end links and remove the end links. (IMAGE 1)
3. Using a 13mm socket, remove the nuts from the u-bolts that mount the sway bar to the rear end. Remove the OE sway bar.
See IMAGE 2.
4. Using a 13mm socket, remove the (2) bolts from the sway bar end link mounting brackets then remove the brackets as shown
in IMAGE 3 below.
5. Locate the BMR frame mounts and begin with the passenger side. Bolt the BMR mount on to the frame using the OE
mounting bolts. Tighten to 38 ft/lbs. (IMAGE 4)
CONTINUED