BMR Suspension TAS002 - Manual (Page 8)

8
(CONTINUED)
40. At this point it is necessary to assemble the coil-over shocks. Using Image 19 as a guide,
thread the lower
adjusters onto the
shock body and
continue
threading until
they are all the
way to the
bottom. Place a
spring over the
shock and then
insert the upper
spring mount on
top of the spring
and over the shock shaft. Thread the
lower shock adjuster up until the spring
has no more slack and seats squarely on
the upper and lower mounts. Slide the
upper mount of the shock into the BMR
cross-member making sure the shock
adjustment knobs are facing inward.
Insert the supplied ½” x 2.5” bolt. Repeat
for the other side. Thread a stainless
washer and nut onto the bolt and tighten to
80 ft/lbs. Slide a 5/8” stainless washer over
the supplied 5/8” x 4” bolts and slide it
through the bottom shock bushing. Place
another washer on the other side of the
bushing then one of the BMR shock spacers
over the bolt as shown in Image 20 above.
41. Mount the assembly into the upper shock
mount on the shock cross-member. Insert
the supplied ½” x 2.5” bolts. Thread the
stainless washers and nuts onto the exposed
threads and leave finger tight.
42. Mount the bottom of the shock to one of the
middle shock mounting holes located on the
rear of the control arm mount. NOTE: it
may be necessary to raise or lower the rear
end in order to insert the bolt. (Image 21)