BMR Suspension TAS002 User Manual

Page 10

(CONTINUED)

48. Thread the drivers’ side Watts link

arm onto the bottom rod end. The
drivers’ side arm is the one with
the most amount of bend.

(Image 24)

49. Position the other end of the

drivers’ side Watts link arm into
the frame mount. Position it in the
mounting location that places the
Watts link bar as level as possible
when the Watts pivot is vertical
(straight up and down). Insert one
of the provided ½” x 3” bolts.
Thread a stainless washer and nut
onto the exposed threads and
leave finger tight. (Image 25)

50. Duplicate steps 49-50 for the

passenger side Watts link arm.

51. As shown in Image 26, use a

plumb bob to determine proper
axle location. NOTE: it is not
necessary to remove the wheels
and tires to accomplish this, the
measurement can also be taken
from the wheel itself. Hold the
plumb bob against each wheel well
in the same position and measure
the axle location in relation to the
fender. Adjust the rod ends until
each wheel measurement is equal
while the Watts link pivot remains
vertical (not angled).