American Fibertek CX-6p-PoE - Manual (Page 47)

47
Reboot
The Reboot screen allows the user to perform a hardware reset of the CX-6p-PoE. This
will not affect the state of the stored configuration files, but will cause all CX-6p-PoE
systems to reset as if a power interruption had occurred. A single button, “Click here to
reboot”, is provided to restart the system.
The CX-6p-PoE takes approximately 10 seconds to reboot and return to full function
after this function is used.
When the CX-6p-PoE is being reset, the aux contact output turn OFF until the reset
cycle is completed, at which time it will behave as configured on the ‘Aux Setup’ page.
Any messages to change aux outputs from other devices on the network will be ignored
while the device is rebooting. Alarm conditions on the alarm input terminal will also be
ignored while the device is rebooting.
When the CX-6p-PoE is rebooting, all serial data links over the network will be dropped.
The unit will attempt to reestablish them once it has finished rebooting, but any data
arriving on the serial ports during the reboot cycle will be lost.