HP ProLiant ML310 G2 Server - Manual (Page 41)

Hardware Options Installation 41
CAUTION: Heatsink retaining screws should be tightened in
diagonally opposite pairs (in an "X" pattern).
7. Connect the fan cable to the system board.
8. Replace the access panel ("Removing the Access Panel" on page 22 ).
Memory Options
You can expand server memory by installing PC-3200 DDR SDRAM DIMMs
with Advanced ECC. The system supports up to four DIMMs for a maximum of
4 GB.
Refer to "System Board Components (on page 11 )" for DIMM slot locations and
bank assignments.
DIMM Installation Guidelines
Observe the following guidelines when installing additional memory:
•
•
DIMMs installed in the server must be Unbuffered DDR DRAM, 2.5 volts,
64 bits wide, and ECC.
If only a single DIMM is installed, it must be installed in slot 1A.