Send a fax using monitor dialing, Send a fax from memory – HP Officejet J4680 User Manual
Page 47
Send a fax using monitor dialing
Monitor dialing allows you to dial a number from the device control panel as you would
dial a regular telephone. When you send a fax using monitor dialing, you can hear the
dial tones, telephone prompts, or other sounds through the speakers on the device.
This enables you to respond to prompts while dialing, as well as control the pace of
your dialing.
TIP: If you do not enter your calling card PIN fast enough, the device might start
sending fax tones too soon and cause your PIN not to be recognized by the calling
card service. If this is the case, you can create a speed dial entry to store the PIN
for your calling card.
NOTE: Make sure the volume is turned on, or you will not hear a dial tone.
To send a fax using monitor dialing from the device control panel
1. Load your originals. For additional information, see
automatic document feeder (ADF)
.
2. Press the the left arrow or the right arrow to select Fax B&W or Fax Color,
and then press Start.
If the device detects an original loaded in the automatic document feeder, you will
hear a dial tone.
3. When you hear the dial tone, enter the number by using the keypad on the device
control panel.
4. Follow any prompts that might occur.
TIP: If you are using a calling card to send a fax and you have your calling
card PIN stored as a speed dial, when prompted to enter your PIN, press
Speed Dial to select the speed dial entry where you have your PIN stored.
Your fax is sent when the receiving fax machine answers.
Send a fax from memory
You can scan a black-and-white fax into memory and then send the fax from memory.
This feature is useful if the fax number you are trying to reach is busy or temporarily
unavailable. The device scans the originals into memory and sends them once it is
able to connect to the receiving fax machine. After the device scans the pages into
memory, you can immediately remove the originals from the document feeder tray.
NOTE: You can only send a black-and-white fax from memory.
To send a fax from memory
1. Load your originals. For additional information, see
.
2. Press the the left arrow or the right arrow to select Fax B&W or Fax Color,
and then press OK.
3. Enter the fax number by using the keypad, press Speed Dial to select a speed
dial, or press Redial/Pause to redial the last number dialed.
4. Press the right arrow until Fax Method appears, and then press OK.
Send a fax
43