Verify component operation – HP MSA 2040 SAN Storage User Manual

Page 90

SFP option for host ports

The installed SFP should look similar to the position shown in the right detail view.

When ready to attach to the host, obtain and connect a qualified cable option to the duplex jack at the

end of the SFP connector.

NOTE:

To remove an SFP module, perform the above steps in reverse order.

Verify component operation

View the host port Link Status/Link Activity LED on the controller module face plate. A green LED indicates that

the port is connected and the link is up (see

for information about controller module LEDs).