Configure bluetooth settings on a network printer – HP Deskjet 6943 Printer User Manual
Page 31
●
Configure
●
Visit HP's Web site for support
information and to purchase supplies.
Caution
It is recommended that the printer and the computers that use it be on
the same
. Printer installation across subnets can be problematic
depending on the type of router used.
Before using the printer's internal Web page, verify that the printer and the computer are
powered on and connected to the network.
Open the embedded Web server
Follow these steps to open the printer's internal Web page:
1.
Launch the Internet browser.
Use Microsoft Internet Explorer 5.0 or higher or Netscape 4.75 or higher.
2.
Enter either the printer's
in the browser's address box.
Note
If the printer is on a different
printer's IP address (for example: http://192.168.1.1) in the browser's
address box to open the embedded Web server. Also, if the computer uses
a proxy server to access the Internet, you might need to configure the
browser to by-pass the proxy server in order to access the EWS.
If you do not know the printer IP address or host name,
.
Configure Bluetooth settings on a network printer
The following table describes the Bluetooth settings you can configure on the
Bluetooth tab of the printer's
if the printer is connected
to the network with an Ethernet cable:
Note
If your printer is not connected to a network, connect a USB cable from
your computer to the rear USB port on the printer and open the
to configure the Bluetooth settings.
Parameter
Description
Device Address
The hardware address of the Bluetooth device.
Note
You cannot change this address.
Device Name
The device name assigned to the printer so that other
Bluetooth devices can identify it.
Passkey
A 4-digit value that the user must enter in order to print using
Bluetooth. The default passkey is 0000.
(continued)
User's guide
29