HP Color LaserJet 5550 Printer series - Manual (Page 77)

Configuring TCP/IP parameters
You can use the printer control panel to configure the following TCP/IP parameters:
● usage of the BOOTP file for configuration parameters (the default is to use the BOOTP
file)
● IP address (4 bytes)
● subnet mask (4 bytes)
● default gateway (4 bytes)
● idle TCP/IP connection timeout (in seconds)
To automatically configure TCP/IP parameters from the printer control
panel
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press to select EIO X.
8. Press to highlight TCP/IP.
9. Press to select TCP/IP.
10. Press to select CONFIG METHOD.
11. Press to highlight AUTO IP.
12. Press to select AUTO IP.
13. Press the M
ENU
button to return to the Ready state.
To manually configure TCP/IP parameters from the printer control panel
Use manual configuration to set an IP address, subnet mask, and local and default gateway.
Setting an IP address
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to select EIO X.
7. Press to highlight TCP/IP.
8. Press to select TCP/IP.
9. Press to highlight MANUAL SETTINGS.
ENWW Network configuration 63