HP Color LaserJet 5550 Printer series - Manual (Page 76)

Network configuration
You might need to configure certain network parameters on the printer. You can configure
these parameters from the printer control panel, the embedded Web server, or for most
networks, from the HP Web Jetadmin software (or the HP LaserJet Utility for Macintosh).
Note For more information about using the embedded Web server, see Using the embedded Web
server . For more information about using the HP Toolbox, see Using the HP Toolbox .
For a complete list of supported networks and for instructions on configuring network
parameters from software, see the HP Jetdirect Print Server Administrator’s Guide. The
guide comes with printers in which an HP Jetdirect print server is installed.
This section contains the following instructions for configuring network parameters from the
printer control panel:
● configuring TCP/IP parameters
● disabling unused network protocols
● configuring Novell NetWare frame type parameters
Configuring Novell NetWare frame type parameters
The HP Jetdirect print server automatically selects a NetWare frame type. Select a frame
type manually only when the print server selects an incorrect frame type. To identify the
frame type chosen by the HP Jetdirect print server, print a configuration page from the
printer control panel. See
Printer information pages .
To configure the Novell NetWare parameters from the printer control
panel
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press to select EIO X.
8. Press to highlight IPX/SPX.
9. Press to select IPX/SPX.
10. Press to highlight FRAME TYPE.
11. Press to highlight the desired frame type.
12. Press to select the frame type.
13. Press the M
ENU
button to return to the Ready state.
62 Chapter 3 I/O Configuration ENWW