Prints do not fall nicely into the basket, The paper is cut when the print has been completed, The cutter does not cut well – HP Designjet T610 Printer series User Manual
Page 130
10.
Switch on the printer.
11.
Reload the roll, or load a new sheet see
.
NOTE:
If you find that there is still some paper causing an obstruction within the printer, restart the
procedure and carefully remove all pieces of paper.
The printer displays out of paper when paper is available
If the roll has become loose from its core, it will not feed correctly and the printer will not load the paper.
If possible, tighten the paper to its core or load a new roll.
Prints do not fall nicely into the basket
●
Ensure the basket is correctly installed.
●
Ensure the basket is open.
●
Ensure the basket not full.
●
Paper often tends to curl near the end of a roll, which can cause output problems. Load a new roll,
or remove prints manually as they are completed.
The sheet stays in the printer when the print has been
completed
The printer holds the paper to allow the print to dry after printing, see
. If the paper is only partially ejected after the drying time, gently pull the sheet out of the
printer. If the automatic cutter is disabled, use the
Form feed and cut
key
on the front panel, see
Feed and cut the paper on page 45
.
The paper is cut when the print has been completed
By default the printer cuts the paper after the drying time has been completed, see
. You can disable the cutter, see
Turn the automatic cutter on and off on page 45
The cutter does not cut well
By default the printer is set to automatically cut the paper after the drying time has been completed.
120 Chapter 12 Troubleshooting paper issues
ENWW
Paper issues