HP Storage Mirroring Software - Manual (Page 99)

15 - 13
4043 Service Error This product can only be run
on a limited number of
processors and this server
exceeds the limit. The
product functionality has
been disabled.
Reinstall the software, using
the installation Repair
option, to install a new copy
of the RSResource.dll.
Contact technical support if
this error persists.
4044 Service Error An error was encountered
and replication has been
stopped. It is necessary to
stop and restart the service
to correct this error.
Contact technical support if
this error persists.
4045 Service Error %1 value must be between
1025 and 65535. Using
default of %2.
Verify that the Storage
Mirroring port value you are
trying to use is within the
valid range. If it is not, it will
automatically be reset to the
default value.
4046 Service Error This service failed to start
because of a possible port
conflict. Win32 error: %1
Verify that the Storage
Mirroring ports are not
conflicting with ports used by
other applications.
4047 Service Error Could not load ZLIB DLL %1.
Some levels of compression
will not be available.
The compression levels
available depend on your
operating system. You can
reinstall the software, using
the installation Repair
option, to install a new copy
of the DynaZip.dll, or contact
technical support if this error
persists.
4048 Service Info. Service has started a delete
orphans task to %1 (%2) for
Replication Set %3, ID: %4
No action required.
4049 Service Info. Service has paused a delete
orphans task to %1 (%2) for
Replication Set %3, ID: %4
No action required.
4050 Service Info. Service has resumed a delete
orphans task to %1 (%2) for
Replication Set %3, ID: %4
No action required.
4051 Service Info. Service has stopped a delete
orphans task to %1 (%2) for
Replication Set %3, ID: %4
No action required.
4052 Service Info. Service has completed a
delete orphans task to %1
(%2) for Replication Set %3,
ID: %4
No action required.
4053 Service Info. Service has started a restore
task to %1 (%2) for
Replication Set %3, ID: %4
No action required.
4054 Service Info. Service has paused a restore
task to %1 (%2) for
Replication Set %3, ID: %4
No action required.
4055 Service Info. Service has resumed a
restore task to %1 (%2) for
Replication Set %3, ID: %4
No action required.
ID Category Severity Event Message Required Response