HP Storage Mirroring Software - Manual (Page 101)

15 - 15
4150 Service Error Target write %1 failed after
%2 retries and will be
discarded. See the event log
or log files for error
conditions. After correcting
the problem, you should
re-mirror or run a verify to
resynchronize the changes.
The operation has been
retried according to the
TGExecutionRetryLimit
setting but was not able to be
written to the target and the
operation was discarded.
Correct the problem and
remirror the files.
4200 Service Info. In band task %1 submitted
from %2 by %3 at %4
No action required.
4201 Service Warning In band task %1 discarded
(submitted from %2 by %3
at %4)
A task may be discarded in
the following scenarios: all
connections to a target are
manually disconnected,
replication is stopped for all
connections to a target, or an
auto-disconnect occurs. If
one of these scenarios did
not cause the task to be
discarded, contact technical
support.
4202 Service Info. Running %1 in band script:
%2 (task %3 submitted from
%4 by %5 at %6)
No action required.
4203 Service Info. Completed run of in band
script: %1 (exit code %2)
No action required.
4204 Service Error Error running in band script:
%1
Review the task and its
associated script(s) for
syntax errors.
4205 Service Warning Timeout (%1 seconds)
running in band script: %2
The timeout specified for the
script to complete has
expired. Storage Mirroring
will continue with normal
processing. You may need to
manually terminate the
script if it will never
complete.
4206 Service Warning Run timeout disabled for in
band script: %1
The timeout period was set
to zero (0). Storage Mirroring
will not wait for the script to
complete before continuing.
No action is required.
4207 Service Warning In band scripts disabled by
server - no attempt will be
made to run %1
Enable task command
processing.
4300 Service Error A connection request was
received on the target before
the persistent target paths
could be loaded.
You may need to disconnect
and reconnect your
replication set.
4301 Service Error Unable to block target paths,
the driver is unavailable.
If you need to block your
target paths, contact
technical support.
4302 Service Info. Target Path %1 has been
successfully blocked
No action required.
ID Category Severity Event Message Required Response