Network menu – HP Modular Cooling System Options User Manual
Page 31
Web interface 31
o
Select Off so that the alarm relay is not activated (normally open) upon alarm activation.
9.
Enter a range for the web page automatic refresh interval in the Web Page Automatic Refresh Interval
field.
10.
Do one of the following:
o
Click Save Settings to save the information.
o
Click Clear Alarms to clear the alarms.
NOTE:
To clear the condensation pump cycles warning, click Cooling System in the left
navigation frame to access the Cooling System screen, and then click the Alarms/Warnings tab.
Under the Warnings section, set Alarm Reset to Manual and click Save Settings. Then, return to
the General menu and click Clear Alarms.
This step only clears the warning when the condensation pump is not running.
11.
Click Reset to Factory Defaults to reset the parameters to the defaults set by the factory. You are
prompted to reboot.
o
Click Restart to restart the management module.
o
Click Cancel to undo the changes.
Network menu
Click Network in the left navigation frame to access the Network screen. This screen enables the Admin to
configure network settings for the management module.
To set a static IP:
1.
Select Disable in the DHCP field. DHCP is enabled by default.