HP Modular Cooling System Options - Manual (Page 28)

Web interface 28
• Temperature Control Auto mode—Used for operating the MCS unit after a satisfactory water flow rate
has been reached.
In this mode, the MCS unit operates automatically, according to the settings you have assigned to the
following parameters:
o Delta Temperature For Minimum Fan Speed
o Delta Temperature For Maximum Fan Speed
o Cooling Liquid Heat Capacity
• Temperature Control Manual mode—Used to verify the water flow rate after the cold water supply has
been connected. When the water flow rate has been validated, use the Auto mode setting.
In this mode, the MCS unit operates manually, according to the settings you have assigned to the
following parameters:
o Fan Speed Target
o Water Valve
After you change the temperature control modes, you can do the following:
o Click Save Settings to save the information.
o Click Cancel to undo the changes.
Automatic Door Release Kit
To view the HP Automatic Door Release hardware installation instructions, see the HP mc-Series 5042 Rack
Options Installation Instructions.
To enable the automatic door release:
1. Click Setup>Advanced.
2. In the Emergency Door Opening field, select Enable.
When the function has been enabled, an indicator appears on the Home tab showing the current status of the
rack doors. Also, a new button appears on the Advanced tab, enabling you to test the feature.