HP LaserJet M9059 Multifunction Printer series - Manual (Page 56)

Print Quality menu
Administration > Print Quality
NOTE: Values shown with "(default)" are the factory-default values. Some menu items have no default.
Table 2-15 Print Quality menu
Menu item Sub-menu item Values Description
Set Registration Test Page Print (button) Print a test page for setting the registration. Follow the
instructions that are printed on the page to adjust each
tray.
Source All trays
Tray :
Tray :
(choose a tray)
Use Set Registration to shift the margin alignment to
center the image on the page from top to bottom and
from left to right. You can also align the image on the
front with the image printed on the back.
Select the source input tray for printing the Set
Registration page.
Adjust Tray Shift from -20 to 20 along
the X or Y axes.
0 is the
default.
Perform the alignment procedure for each tray.
When it creates an image, the device scans across the
page from side to side as the sheet feeds from top to
bottom into the device.
Fuser Modes Standby Fuser Mode 125° Celsius
Off
Set the temperature of the fuser when the MFP is in
standby mode.
Configure the fuser mode associated with each media
type.
Restore Modes Restore (button) Restore the fuser modes to the default settings.
Resolution 300
600
FastRes 1200 (default)
ProRes 1200
Use this feature to select the print resolution.
REt Off
Light
Medium (default)
Dark
Enable Resolution Enhancement technology (REt),
which produces print output with smooth angles,
curves, and edges. All print resolutions, including
FastRes 1200, benefit from REt.
Economode Enabled
Disabled (default)
When Economode is enabled, the device prints with a
reduced amount of toner per page; however, the print
quality of the page is reduced.
Toner Density Choose from a range of 1
to 5.
3 is the default.
Lighten or darken the print on the page. 1 is the lightest
and 5 is the darkest.
Small Paper Mode Normal (default)
Slow
Choose Slow to adjust the MFP for printing narrow
media.
42 Chapter 2 Control panel ENWW