Enww control-panel messages 155 – HP LaserJet M3027 Multifunction Printer series User Manual
Page 167
Control panel message
Description
Recommended action
or go to
or
.)
22 Embedded I/O buffer overflow To
continue touch OK
Too much data was sent to the embedded
HP Jetdirect print server.
Touch
OK
to print the transferred data. (Some
data might be lost.)
22 Parallel I/O buffer overflow To continue
touch OK
Too much data was sent to the parallel port.
Touch
OK
to clear the error message. (Data
will be lost.)
Check for a loose cable connection, and be
sure to use a high-quality cable. Some non-
HP parallel cables might be missing pin
connections or might otherwise not conform
to the IEEE-1284 specification. Go to
22 USB I/O buffer overflow To continue
touch OK
Too much data was sent to the USB buffer.
Touch
OK
to clear the error message. (Data
will be lost.)
30.1.YY Scanner failure
An error has occurred in the scanner.
Turn the device off and then on.
If this message persists, contact an HP-
authorized service or support provider. (See
the HP support flyer, or go
40 Bad serial transmission To continue
touch OK
A serial data error (parity, framing, or line
overrun) occurred as data was being sent by
the computer.
Touch
OK
to clear the error message. (Data
will be lost.)
40 EIO
touch OK
The connection between the device and the
EIO card in the specified slot has been
broken.
Touch
OK
to clear the error message and
continue printing.
40 Embedded I/O bad transmission To
continue touch OK
A temporary printing error has occurred.
Turn the device off, and then turn the device
on.
If this message persists, contact an HP-
authorized service or support provider. See
the HP support flyer, or go
41.3 - Load tray
touch OK
The specified tray does not contain the
specified media size.
Touch
OK
to use a tray that contains media
of the correct size.
41.3 - Load tray
The specified tray is loaded with media that
is longer or shorter in the feed direction than
the size configured for the tray.
Touch
OK
to display Tray
Reconfigure the size in a tray so that the
device will use a tray that is loaded with the
size of media required for the print job. If the
message does not clear automatically from
the control-panel display, turn the device off,
and then turn the device on.
41.X Error To continue touch OK
A temporary printing error occurred.
Touch
OK
to clear the error. If the error is not
cleared, turn the device off, and then turn the
device on.
If this message persists, contact an HP-
authorized service or support provider. (See
the HP support flyer, or go
Table 11-1
Control-panel messages (continued)
ENWW
Control-panel messages
155