HP Integrated Lights-Out 3 - Manual (Page 142)

#
# Decode the range
#
if ($range =~ m/([0-9A-Fa-f]+)-([0-9A-Fa-f]+)/) {
$start = hex($1);
$end = hex($2);
$len = $end - $start + 1;
}
#
# Decode the data (a big hexadecimal string)
#
$decode = pack("H*", $data);
#
# Write it to the target file
#
sysopen(F, $file, O_RDWR);
binmode(F);
sysseek(F, $start, SEEK_SET);
syswrite(F, $decode, $len);
close(F);
print "Content-Length: 0\r\n";
print "\r\n";
Configuring Virtual Media Boot Order
The Virtual Media Boot Order feature enables you to set the server boot options. You must have
the Virtual Media and Configure iLO Settings privileges to change these settings.
NOTE: Changes made to the boot order or one-time boot status might require a server reset. iLO
will notify you when a reset is necessary.
Changing the server boot order
To change the boot order of floppy, CD/DVD-ROM, USB, hard disk, and network devices:
1.
Navigate to the Virtual Media
→Boot Order page, as shown in
Figure 76 (page 142) .
Figure 76 Boot Order page
142 Using iLO