HP Brocade 8Gb SAN Switch for HP BladeSystem c-Class - Manual (Page 14)

Using Enclosure Bay IP Addressing (EBIPA)
To set the Ethernet IP address using EBIPA:
1.
Open a web browser and connect to the active OA.
2. Enable EBIPA for the corresponding interconnect bay.
3. Click Apply to restart the switch.
4. Verify the IP address using a Telnet or SSH login to the switch, or by selecting the switch in
the OA GUI Rack Overview window.
NOTE: See the HP BladeSystem Onboard Administrator User Guide for additional information
on EBIPA.
Using external DHCP
To set the Ethernet IP address using external DHCP:
1.
Connect to the active OA with a web browser.
2. Document the DHCP-assigned address by selecting the switch from the OA GUI Rack Overview.
3. Verify the IP address using a Telnet or SSH login to the switch, or select the switch in the OA
GUI Rack Overview window.
Setting the IP address manually
To set the IP address manually:
NOTE: As an alternate method to using a null modem cable, use Telnet or SSH to access the IP
address of the Onboard Administrator, resuming at Step 9 .
1. Obtain the following items to set the IP address with a serial connection:
•
Computer with a terminal application (such as HyperTerminal in a Windows environment
or TERM in a UNIX environment)
•
Null modem serial cable
2. Replace the default IP address (if present) and related information with the information provided
by your network administrator. By default, the IP address is set to 10.77.77.77 for switches
with revision levels earlier than 0C.
3. Verify that the enclosure is powered on.
4. Identify the active OA in the BladeSystem.
5. Connect a null modem serial cable from your computer to the serial port of the active OA.
6. Configure the terminal application as follows:
In a Windows environment, enter:
•
Bits per second—9600
•
Databits—8
•
Parity—None
•
Stop bits—1
•
Flow control—None
In a UNIX environment, enter tip /dev/ttyb –9600
7. Log in to the OA.
8. Press Enter to display the switch console.
14 Setup