HP Brocade 8Gb SAN Switch for HP BladeSystem c-Class - Manual (Page 13)

5. Press the installation handle into the latch to lock the Brocade 8Gb SAN Switch in place.
CAUTION: For proper cooling and EMI emissions control, all panels and doors should be in
place and securely fastened while the unit is in operation.
OA power verification
The HP BladeSystem Onboard Administrator (OA) is the enclosure management processor that
manages the devices contained within the enclosure. The OA provides a single point from which
to perform basic management tasks on switches or server blades installed in the enclosure.
IMPORTANT: HP recommends reading the appropriate HP BladeSystem Enclosure User Guide
and the HP BladeSystem Onboard Administrator User Guide. Reading these guides in sequence
promotes an overall understanding of your specific enclosure model.
Once the switch is installed in the interconnect bay, the OA verifies that the switch type matches
the mezzanine cards present on the servers. If there is no mismatch, the OA powers up the switch.
If the switch does not power up, check the enclosure and switch status with the OA web interface.
See HP BladeSystem Onboard Administrator User Guide.
Check LEDs
See Figure 6 (page 13) to locate power-on LEDs. Verify that the LEDs match the indicators described
below the figure
Figure 6 Verifying power-on LEDs
Off 1. UID LED
Steady green light 2. Health ID LED
Steady green light 3. Module status LED
Steady green light 4. Port status LED
Set the switch Ethernet IP address
To set the Ethernet IP address:
1.
Verify that the enclosure is powered on.
2. Verify that the switch is installed.
3. Choose one of the following methods to set the Ethernet IP address:
•
Using Enclosure Bay IP Addressing (EBIPA)
•
“Using external DHCP” (page 14)
•
“Setting the IP address manually” (page 14)
Set the switch Ethernet IP address 13