Section 7 ftp (file transfer protocol), Network settings, Section 7 – Axis Communications CD E100 User Manual
Page 79: Ftp (file transfer protocol), Section 7 - ftp (file transfer protocol)
Section 7: Section 7: FTP (File Transfer Protocol)
AXIS StorPoint CD E100 User’s Manual
79
Section 7 FTP (File Transfer Protocol)
This section describes how to configure the StorPoint CD for FTP.
The StorPoint CD can be used as an FTP server, i.e. it is possible to use the File
Transfer Protocol (FTP) to put and get files. You can use FTP for:
•
Upgrading the firmware
•
Accessing the mounted discs
Note:
❏ The FTP protocol is always enabled in the StorPoint CD.
The following FTP commands are supported:
If you intend to use StorPoint CD in a multiprotocol environment, proceed to
the other relevant sections in this manual:
•
“Section 3 - Microsoft & IBM Networks (SMB) ”
•
•
•
“Section 6 - Macintosh (AFP) ”
•
“Section 8 - Web Browser (HTTP) ”
Network Settings
Use the Administration pages within the StorPoint CD Web interface to specify
the FTP settings. Follow these steps:
1. Start your Web browser, and enter the name or IP address of the StorPoint
CD in the location/address field.
2. Click admin. You will be prompted for the Server password. By default, this
is set to
pass
. To change the Server password, see “Server Password” on page
3. Click Network Settings.
4. Click Detailed View .
The
Protocols dialog box appears.
get
put
dir
cd
pwd