Axis Communications CD E100 - Manual (Page 16)

Section 2: Installing the StorPoint CD
16 AXIS StorPoint CD E100 User’s Manual
ARP in Windows 95,
Windows 98 and
Windows NT
Perform the following commands to download the IP address and verify correct
Internet communication in Windows 95/98/2000/ME and Windows NT.
Start a DOS window and type the following command:
Syntax Windows 95
where is the IP address of your Windows 95 PC.
Example Windows 95
Syntax Windows 98/2000/ME and Windows NT
Example Windows 98/2000/ME and Windows NT
The host will return ‘ Reply from 192.16.253.80 ... ’ or some similar
message. This indicates that the address has been set and the communication is
established.
Notes:
❏ Once the StorPoint CD has established communication using an
appropriate IP address, the arp command cannot be used to change the
address. This is to avoid accidental or unauthorized changes. However, if
you restart the StorPoint CD, you can change the IP address within 30
minutes.
❏ Please note that when you execute the
ping
command for the first time, you
will experience a significantly longer response time than usual.
❏ If you are using host names, you can map a unique host name to the
acquired IP address. Refer to your system manuals or to the Network
Administrator for instructions on how to perform the name mapping on
your particular system.
arp -s
ping
arp -s 192.16.253.80 00-40-8c-10-00-86 171.16.6.40
ping 192.16.253.80
arp -s
ping
arp -s 192.16.253.80 00-40-8c-10-00-86
ping 192.16.253.80