Running a diagnostic test, Before you begin, Procedure – Axis Communications CD E100 User Manual
Page 133
Appendix B: Troubleshooting
AXIS StorPoint CD E100 User’s Manual
133
Running a Diagnostic Test
The StorPoint CD Web Pages include a diagnostic test that you can run in order
to check the memory and the performance of the connected drives.
Before You Begin
Note the following:
•
Users that are currently accessing the StorPoint CD will be interrupted.
•
The diagnostic test is only available the first hour after startup.
•
If you want to repeat the test, you must first restart the StorPoint CD.
•
In order to test the data transfer performance of a drive, a disc including a
file larger than 10 MB must be inserted.
Procedure
To perform the diagnostic test, follow these steps:
1. Start the Web browser, and enter the URL of the Diagnostics page in the
location/address field:
Example
2. The Diagnostics page appears:
Make sure a suitable disc is inserted into each of the drives you want to test.
3. Start the diagnostic test by simply reloading/refreshing the Diagnostics page.
The test takes a few minutes to complete.
4. Reload/refresh the page once again to display the results.
http://
http://192.16.253.80/this_server/diag.shtml