HP RDX Removable Disk Backup System - Manual (Page 29)

Power LED
Table 3 Power LED
LED Status Meaning Action required
OFF No power
Check the power cable connection and replace the cable
if necessary. You can use the power cable from your
monitor or another device to check that the connection is
working.
If the power supply is present and the LED remains off,
power cycle or reset the drive. If it still fails, call for
service.
Steady GREEN
The drive is ready
for operation
None. This is normal.
Blinking GREEN Ejecting None. The unit is ejecting the cartridge.
Steady AMBER Fault
The unit has detected a fault condition. This may be
because:
• the unit cannot eject the cartridge due to an
obstruction
• the internal electronics are damaged or
malfunctioning
Use a straightened paper clip in the Emergency Eject
Hole to remove a stuck cartridge, as described in
“ Emergency eject ” on page 30. If this does not resolve
the problem, run the RDX diagnostic application.
Blinking AMBER Prevent
None. The host server is accessing the media and the
user has pressed the eject button. The unit will blink
amber for a few seconds then return to steady green.
Wait for host access to complete, after which the unit
will eject the cartridge. If it does not, you may not be
running the correct RDX utility, see “ RDX Removable Disk
utility ” on page 12. Install the RDX utility and try again.
If necessary, use Windows Explorer to eject the cartridge
(right-click on the drive letter for the RDX Removable Disk
Backup System and select Eject).
RDX Removable Disk Backup System 29