HP Insight Management Agents - Manual (Page 104)

◦ noDigest
◦ crc32c
Sub-system Classification
Power Subsystem
This section displays information about the redundant power supplies. The following entries may
be displayed:
•
Location—Displays the bay where the power supply is located.
•
Condition—Displays the status of the power supply. The following values are possible:
OK—A power supply is installed and operating normally. ◦
◦ Failed—A power supply is installed and is no longer operating. Replace the power supply.
◦ Not Installed—Nothing is installed in this power supply bay.
◦ Unknown—The Server Agent is unable to determine if this storage system power supply
bay is occupied.
•
Serial Number—Displays the serial number of the power supply. This information can be used
for identification purposes.
•
Firmware Revision—Displays the firmware revision of the power supply.
•
Present—Represents whether the power supply is present in the chassis.
•
Status—Represents the status of the power supply in the chassis. The following values are
possible:
◦ No Error
◦ General Failure
◦ Bist Failure
◦ Fan Failure
◦ Temperature Failure
◦ Interlock Open
◦ EPROM Failed
◦ VREF Failed
◦ DAC Failed
◦ RAM Test Failed
◦ Voltage Channel Failed
◦ Orring Diode Failed
◦ Brownout
◦ Give Up On Startup
◦ NVRAM Invalid
◦ Calibration Table Invalid
◦ If the power supply is absent, the status is "Not Applicable"
•
Used Capacity (%)—Represents the current power supply capacity which is a percentage of
its maximum capacity.
•
Used Capacity (W)—Represents the current power supply capacity in watts.
104 Agent information