HP Modular Cooling System - Manual (Page 9)

Installation 9
1. M6 screws (50)
2. Cage nut insertion tool (1)
3. M5.5 x 10 self tapping screws (6)
4. M6 cage nuts (50)
5. T-25 Torx bit (1)
6. Cable management bracket (6)
7. Rack ID plate (1)
8. Leveling foot base (6)
9. Documentation CD (1)
10. Hook-and-loop cabling strap 12.7-cm (5 in) clip (1)
11. Hook-and-loop cabling strap 20.3-cm (8 in) clip (1)
12. Hook-and-loop cabling strap 30.5-cm (12 in) clip (1)
Required tools
The following tools are required for installation:
• Flat blade screwdriver
• #2 Phillips screwdriver
• Adjustable wrench
• T-25 Torx screwdriver
• T-30 Torx screwdriver
• Bubble level
• Hose wrenches (2)
Installing the MCS 5042 unit
WARNING: The MCS 5042 unit and rack are shipped together on a heavy duty shock pallet
weighing approximately 1600 kg (3600 lb). HP recommends hiring professional movers to move
the heavy duty shock pallet, remove the MCS 5042 unit and rack from the pallet, and move the
MCS 5042 unit and rack to the final location.
CAUTION: Contaminated water might cause decreased cooling capacity or disruption in
service. The water flowing into the MCS 5042 unit must meet the guidelines stated in the HP
mc-Series 5042 Rack Site Preparation Guide. The HP mc-Series 5042 Rack warranty does not
cover damage caused by contaminated water.
IMPORTANT: Because the MCS 5042 unit consumes a large quantity of water, HP recommends
that you do not operate the MCS 5042 unit from a public water system such as one that supplies
drinking water. For water conservation purposes, to cool the MCS 5042 unit, use only recycled
water systems.
IMPORTANT: Before you begin the installation process, review the HP mc-Series 5042 Rack Site
Preparation Guide.