HP Modular Cooling System User Manual
Page 10
Installation 10
1.
Install the HP mc-Series 5042 Hook Up Kit.
2.
Read the unpacking instructions on the MCS 5042 packaging material.
3.
Using four or more people, remove the HP mc-Series 5042 Rack unit and rack from the pallet.
4.
Roll the HP mc-Series 5042 Rack unit and rack to the final location.
WARNING:
To avoid tipping the MCS 5042 unit over, make sure the leveling feet are lowered
when the MCS 5042 is equipped, serviced, and operated.
5.
To adjust the leveling feet and level the MCS 5042 unit, use a bubble level.
6.
Plug the network cable into the RJ-45 connector on the transfer switch in the top of MCS 5042 unit.
7.
Plug the other end of the network cable to your network connection.
WARNING:
Before you connect the power cords to a power source, be sure that the unit is
properly grounded for potential equalization caused by high leakage current.