HP XP Command View Advanced Edition Software - Manual (Page 295)

System configuration
This section uses examples to describe how to use extended commands. The example here assumes
that the system is configured to use one database server, but you can also configure the system to
use multiple database servers.
Figure 85 System configuration for backing up an SQL Server database to tape and restoring it from
tape
Application Agent allows you to use a cluster configuration for database servers. If a failover cluster
configuration is used for the database servers, the active server can be switched to the standby server
when a failure occurs on the active server.
The examples in this section assume the following conditions:
• The primary volume is NTFS-formatted.
• The primary volume and the secondary volume are pair defined in the database server and the
backup server.
• The tape backup management software is installed on the backup server.
• The parameters of the tape backup management software have been registered by using the
drmtapeinit command.
Application Agent CLI User Guide 295