Avaya P334T-ML - Manual (Page 67)

Chapter 8 User Authentication
Avaya P334T-ML User’s Guide 51
L Enabling and disabling the Telnet-client service can only be done using a direct
console connection via the Console port.
By default the Telnet-client service is disabled.
Telnet Commands
The following Telnet commands are available.
For a complete description of the Telnet CLI commands, including syntax and
output examples, refer to Avaya P330: Reference Guide.
Recovery Password
Introduction
The P330 provides a recovery password in the event that you have forgotten the
login password for the switch. The recovery password feature enables you to login
to the device in a super user mode and change the regular login password.
The recovery password feature can be disabled preventing unauthorized user to
login to the device using the recovery password. However, if the recovery password
feature is disables and you forget the login password, it will not be possible to log in
to the switch. By default the recovery password feature is enabled.
To use the recovery password feature, you must connect to the switch’s console
port. Log in using the user name “root” and password “ggdaseuaimhrke”. Use the
set username command to change the password for the user “root”.
L Enabling and disabling the Recovery Password protocol can only be done using
a direct console connection via the Console port.
Recovery Password Commands
In order to... Use the following command...
Open a Telnet session to another
device. telnet
Enable Telnet access from the
switch ip telnet-client enable
Disable Telnet access from the
switch no ip telnet-client