HP System Management Homepage-Software - Manual (Page 63)

Custom UI
Enabling custom UI enables you to customize the sign-in and header images as well as adding a
small text in the sign-in page. See the HP SMH README.txt in the hpsmh/data/htdocs/
custom_ui
directory in the HP SMH install path.
smhconfig -c|--custom-ui[=] True | False
Log-based directory
To define a particular directory location (path) to the smh error_log and access_log, use
the following command:
smhconfig -O|--log-base-dir[=] DIR
where, DIR is the directory location (path) of the directory where the log is to be saved.
Configurable logging
To configure the logs in HP SMH, execute the following command:
smhconfig -q |--config-level[=] Informational | Minor | Warning | Major
| Critical where, Informational, Minor, Warning, Major, and Critical are the logging levels
in HP SMH.
Execute the following command to restart the HP SMH service smhconfig -r.
Any logs of severity greater than or equal to the configuration level set is logged in the
smh_enc.log
file.
Autostart mode
Autostart mode is a feature in HP SMH which, if enabled, stops the Apache server after a
user-specfied timeout (server timeout) period to optimize the system resources. Beyond the server
timeout period set, HP SMH cannot be accessed through port 2381 until it is accessed via port
2301 and thus auto starting HP SMH on port 2381.
Autostart mode is supported for systems running on Linux operating systems. By default, in HP SMH
6.2 first installation, Autostart mode is disabled on the HP SMH systems. It can be enabled either
from the GUI or through the Command Line Interface.
To configure autostart mode start up from the Command Line Interface, execute the following
command:
smhconfig -D|--autostart TRUE|FALSE
where, selecting TRUE enables the autostart mode and FALSE disables the autostart mode.
When Autostart mode is enabled, you can set the timeout in minutes for the server timeout value
between 1 and 60 minutes (default value is 30 minutes)
To set the server timeout in minutes, execute the following command: smhconfig
-F|--timeoutsmh(1-60)
where, (1-60) corresponds to the time in minutes for the server timeout.
Restart the HP SMH application for the Apache server to use the newly-configured values.
NOTE: Enabling the Autostart mode enables port 2301.
Httpd Error log
The httpd error log option enables you to determine if it is possible to view the httpd error_log
log file through the user interface.
smhconfig -p|--httpd-error-log[=] True | False
Custom UI 63