HP SmartStart-Software - Manual (Page 57)

Toolkit utilities 57
Command-line argument Description
-get_hostinfo This argument returns the host server name and serial number.
-m This argument indicates to HPONCFG the minimum firmware level that
must be present in the management device to execute the RIBCL script. If
the minimum level is not met, HPONCFG returns an error without
performing any additional actions.
-mouse This argument causes HPONCFG to configure the server for optimized
mouse handling.
HPONCFG return codes
Value Meaning
0 The script was sent successfully to the device.
1 The script could not be sent to the device. There is an error in xml.
2 The Management processor is not present, or the driver is not running.
3 The iLO flash is still in progress.
255 The script is unable to create an output file.
If the script itself fails, errors are reported in the log file created by HPONCFG.
HPONCFG command file contents
HPONCFG can be used to perform the following tasks:
• Obtain an entire configuration
• Obtain a specific configuration
• Set a configuration
Obtaining an entire configuration
HPONCFG can be used to obtain an entire configuration from an iLO, iLO 2, iLO 3, or a RILOE II. In this
case, the utility executes from the command line without specification of an input file. The name of the
output file is given on the command line. For example:
HPONCFG /w config.xml
In this example, the utility indicated that it obtained the data successfully and wrote it to the output file as
requested. The following is a typical example of the contents of the output file: