HP SmartStart-Software - Manual (Page 45)

Toolkit utilities 45
Method mode Possible values Default value
Auto Yes (indicating one spare)
No In Configure action mode: Yes
(indicating one spare)
In Reconfigure action mode, ACU
ignores any value entered for this
option and keeps any spares that
are already present in the
configuration
Logical Drive category
The Logical Drive category has the following options:
• ArrayAccelerator (on page 45 )
• LogicalDrive (on page 45 )
• LogicalDriveSSPState (on page 45 )
• ParityGroups (on page 46 )
• PreferredPath (on page 46 )
• RAID (on page 46 )
• Sectors (on page 46 )
• Size (on page 46 )
• SSPAdaptersWithAccess (on page 47 )
• StripeSize (on page 47 )
ArrayAccelerator
This option specifies whether the array accelerator is enabled or disabled for the specified logical drive.
The default value is Enabled.
LogicalDrive
The value that you enter for this option specifies the ID number of the logical drive that is to be created or
modified. The first logical drive on an array must have an ID of 1 (not 0), and logical drive numbering
must be contiguous.
• In Configure action mode, ACU accepts only the ID number of the next possible logical drive.
• In Reconfigure action mode, ACU also accepts the ID number of any existing logical drive.
LogicalDriveSSPState
This option is valid only for controllers that enable SSP on a logical drive basis. Other controllers that
support SSP use the SSPState option (" SSPState " on page 43 ).
The following defaults apply:
• For new logical drives, the default value is Disabled.
• For existing logical drives, the default value is the current logical drive setting.