HP SmartStart-Software - Manual (Page 53)

Toolkit utilities 53
HPLPCFG command-line syntax
hplpcfg /s filename hplpcfg /l filename hplpcfg /v
[HBA0] WWID=11223344 HostAdapterBiosEnable=1 SelectBootEnable=1
BootDeviceWWID=22334455 BootDeviceLUN[0]=1111
HPLPCFG command-line arguments
Command-line argument Description
hplpcfg /s filename This argument saves the HBA configuration to the filename.
hplpcfg /l filename This argument loads the HBA configuration to the filename.
hplpcfg /v This argument displays the tool version information.
Where filename has the following format:
[HBA0] Section for each HBA
WWID=11223344 Read-only variable
HostAdapterBiosEnable=1 Your input or current value when read from HBA
SelectBootEnable=1 Your input or current value when read from HBA
BootDeviceWWID=22334455 Your input or current value when read from HBA
BootDeviceLUN[0]=1111 Your input, default LUN, or current value when read from
HBA
HPLPCFG return codes
Value Meaning
0 The command was completed successfully.
1 There was an invalid command line option.
2 There was a file open error.
3 There was an NVRAM checksum error.
4 There was an NVRAM data error.
5 There was no adapter or Emulex HBA found on this host.
6 There was an error retrieving the I/O address.
7 The WWID was invalid because of one of the following:
• An invalid value for WWID and BootDeviceWWID, and not a hex value
• The WWID specified for HBA in the .ini file does not match any HBAs found on the
host (for the /l option only)
8 The LUN was invalid.
0x10 Invalid value; for enable/disable value is not 0 or 1 (for /l option only)
0x11 Incorrect iboot BIOS code loaded (for /l option only)
0xFF General error:
• Initialization error (for both /l and /s option)
• Cannot read HBAs WWPN (for /s option only)