HP SmartStart-Software - Manual (Page 51)

Toolkit utilities 51
Error code Error message Comment or clarification
2843 Invalid size. The specified size is invalid or is not possible with the current
configuration.
2844 Invalid stripe size. The specified stripe size is invalid, or not supported by the
current RAID level, or not possible with the current
configuration.
2845 Invalid sectors. The specified MaxBoot setting is invalid or is not possible
with the current configuration.
2846 Cannot change logical
drive sectors.
You cannot change the MaxBoot setting on a configured
logical drive because doing so causes data loss.
2847 Invalid array accelerator
setting.
The specified array accelerator setting is invalid or is not
supported by the current configuration.
2848 Cannot change logical
drive array accelerator
setting.
You cannot change the array accelerator setting for the
current controller configuration.
2849 Invalid
ClearConfigurationWithDat
aLoss parameter.
—
2850 Controller does not support
RAID Array ID.
—
2851 Invalid RAID Array ID. The scripted RAID Array ID is invalid. Use characters from the
set a–z, A–Z, 0–9, !, @, #, *, (, ), ,, -, _, +, :, ., /, and
[space]. The ID cannot end with a space character or exceed
the maximum number of characters allowed by the controller.
2852 Invalid SSP state. —
2853 Cannot change SSP
settings.
—
2854 Invalid SSP adapter ID. —
2855 Controller does not support
logical drive SSP states. Use
the SSPState controller
command to set the
controller SSP state.
—
2856 Controller does not support
controller SSP state. Use the
LogicalDriveSSPState logical
drive command to set SSP
states for each logical drive.
—
2857 Invalid surface scan delay. —
2861 Controller does not support
redundancy settings. The controller is not redundant or does not support
redundancy settings.
2864 Invalid preferred path
mode.
The specified value for the preferred path mode is not valid,
or the controller is not available.
2865 Invalid preferred path. The specified preferred path is not a valid chassis slot for an
available active controller, or the controller is not available.
2866 Failure opening capture file
.
—