HP SAN Virtualization Services Platform - Manual (Page 58)

See also
“ Create debug command ” on page 22
“ Load debug command ” on page 38
“ Reset debug command ” on page 47
“ Save debug command ” on page 50
“ Set debug command ” on page 50
“ Watch debug command ” on page 71
Show eth
command
Returns the configuration—IP address, subnet mask, and gateway—for the specified Ethernet interface.
Syntax
show eth [interface]
Keyword values
[interface]
Ethernet interface that you are showing: MGMT, GE1, GE2, or GE3
family
IPv4, IPv6
See also
“ Disable eth command ” on page 26
“ Enable eth command ” on page 31
“ Modify eth command ” on page 40
“ Set eth command ” on page 51
“ Show eths command ” on page 58
Show eths
command
Returns the configuration—IP address, subnet mask, MAC base address, and gateway—for the four
Ethernet interfaces: MGMT, GE1, GE2, or GE3.
Syntax
show eths
See also
“ Disable eth command ” on page 26
“ Enable eth command ” on page 31
“ Modify eth command ” on page 40
CLI commands 58