HP ProLiant DL560 Server - Manual (Page 75)

Hardware Options Installation 75
NOTE: If using the power cord anchor, be sure to leave enough slack
in the power cord so that the redundant power supply can be removed
without disconnecting the power cord from the primary power supply.
7. Lock the cable management arm into the operating position.
8. Connect the power cord to the power source.
9. Be sure that the power supply LED is green ("Rear Panel LEDs and Buttons"
on page 12).
10. Be sure that the front panel external health LED is green ("Front Panel LEDs
and Buttons" on page 9).
Expansion Board Options
The server supports PCI and PCI-X expansion boards.
To install an expansion board:
1. Power down the server ("Powering Down the Server" on page 29).
2. Extend the server from the rack, if applicable ("Extending the Server from
the Rack" on page 30).
3. Remove the access panel ("Removing the Access Panel" on page 32).
4. Remove the PCI riser cage ("Removing the PCI Riser Cage" on page 32).
HP CONFIDENTIAL
File Name: 303212-1new.doc Last Saved On: 11/4/02 10:51 AM