Suggested action, Suggest action – HP Virtual Connect Enterprise Manager Software User Manual
Page 51

You can confirm this by accessing the Configure Destination Server screen and then clicking Launch
Array Configuration Utility or by rebooting to Option ROM Configuration for many controllers
(ORCA).
Primary controller configured in the system does not have drives attached
Suggested action
Confirm that your hardware setup is correct and that the correct controller is set to primary in
ROM-Based Setup Utility (RBSU).
Primary controller in system is not supported by this version of Insight Control server
migration
When the destination server is manually booted using the boot CD ISO, the error message The
primary controller in your system is not supported by this version of
Insight Control server migration Boot CD
might appear on the destination server
console.
When the auto-boot option is chosen in step 3 of the migration wizard, the auto-boot of the
destination server fails, the destination server is powered off, and the error The Storage
controller is not supported with this version of Insight Control server
migration
might be displayed.
Suggested action
1.
Verify the primary controller is supported for Insight Control server migration. For a complete
list of supported controllers, see the HP Insight Management Support Matrix at the following
website:
2.
Verify the latest firmware is installed on the storage controller.
3.
If the Insight Control server migration Boot CD ISO cannot detect the storage controller, you
may need to reconfigure the storage controller environment variable.
a.
Reboot the destination server to Rom-Based Setup Utility (RBSU) by pressing the F9 key
during POST.
b.
Select the Boot Controller Order option and verify the proper boot order for the storage
controllers.
c.
Press Esc to exit RBSU, and then press F10 to confirm the exit and to save your changes.
d.
Reboot the destination server using the Insight Control server migration Boot CD ISO.
When the destination server boots, the Insight Control server migration Boot CD ISO will
detect the storage controller.
The destination server displays a blank screen when booting to server migration Boot
CD ISO
The destination server might display a blank screen when booting to the server migration Boot CD
ISO if the server has more than 64 GB of RAM.
Suggest action
Perform the following:
1.
At the boot menu, press Esc to enter text mode.
2.
At the text mode boot prompt, typesos mem=4G.
3.
Press Enter.
Destination preparation
51