Suggested action, Migration process, Large volumes fail with server thread error – HP Virtual Connect Enterprise Manager Software User Manual
Page 54
Suggested action
To resolve this issue, manually boot the destination server, and then manually assign the IP address
to the NIC that is on the same network as the application station.
To resolve the gateway issue, ensure that you enter the gateway IP address in the migration wizard
when identifying the destination server.
Warning message is not displayed for unsupported servers when started using the
Insight Control server migration ProLiant Boot CD
HP Insight Control server migration does not support HP ProLiant Server versions G1 to G4. When
the unsupported server is started using the Insight Control server migration ProLiant Boot CD, the
migration wizard does not display the message that the server is not supported.
Suggested action
Before starting the migration, verify if the server is supported. For a list of supported servers, see
HP Insight Management Support Matrix available at:
Microsoft Windows 2008 OS migration results in a blue screen error on destination
server configured with NC551m FCoE card
After a successful X2P migration with primary controller configured as NC551m FCoE Card, the
migration results in a blue screen error.
Suggested action
Before you migrate, you must disable the AMD virtualization or Intel Hyper-Threading in the BIOS
of the destination server.
Migration process
Drivers cannot be installed or injected onto boot disk
This error is reported if Insight Control fails to install or inject device drivers. In most cases, additional
information is reported on the destination server.
Suggested action
Possible causes and solutions for this error include:
•
The boot partition was not migrated to the boot volume on the destination server. Verify that
the boot partition is selected for migration and placed on the boot volume of the destination
server.
•
The network connection failed during driver installation.
•
The destination server failed or was powered down during driver installation.
•
The storage controller where the boot partition was placed is not supported. For a complete
list of supported controllers, see the HP Insight Management Support Matrix at:
•
The iSCSI initiator failed to mount the disk. To resolve this issue, reinstall the iSCSI initiator on
the application station.
Large volumes fail with server thread error
Migrating extremely large volumes (larger than 1 TB) can result in a failed migration with the
following message:
54
Troubleshooting