HP ProLiant DL585 G2 Server - Manual (Page 42)

Hardware options installation 42
When adding hard drives to the server, observe the following general guidelines:
• The system automatically sets all device numbers.
• If only one hard drive is used, install it in the bay with the lowest device number.
• Hard drives must be SFF types.
• Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
• The server supports up to eight SAS or SATA hot-plug hard drives.
Installing a hot-plug hard drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
1. Prepare the hard drive.
2. Install the hard drive into the server. Be sure that the hard drive seats firmly into the connector in the
back of the drive cage.