HP NonStop G-Series - Manual (Page 130)

Appendix C-1
APPENDIX C
Installation Worksheet
Prerequisites for Silo Media Manager to Tandem Installation
To assure a successful installation of Silo Media Manager to Tandem, please make a copy of this
worksheet, fill it out and refer to it during the installation process.
q Services File ________________________
This file is normally located on $SYSTEM.ZTCPIP. This is where the port number
found later in this document will be defined.
q Tandem IP Number ___________________
This IP # is the number of the Tandem which has the SMM server code installed. This
Tandem is physically connected to the Silo via SCSI cable.
q Tandem Port Number __________________
This is the port number to be entered in the services file for the Tandem process that
connects to the SMM server code.
q Host Name ____________________
The name of the Tandem node on which the silo is physically connected.
q Device Name __________________
The SCSI device name of the silo device. The System Manager assigned this name when
he/she connected it to the system.
q Drive Name(s) ___________________
The SCSI device name(s) of the tape drives in the silo.
q Host Drive Names(s) ___________________
The name of the Tandem system which is physically connected to the tapedrive(s) in the
silo. There can be up to 10 drives connected to 1 silo, 1 system for each tape drive.
q SMM Server Name _________________
This will be the process name of the $SYSTEM.TSISMMS0 program. TSI recommend
using $SERV, but any name can be used. The help desk will need the name of the
process should any support be needed.